More info
Description / Abstract:
This test method covers the determination of puncture properties
of rigid plastics over a range of test velocities.
Test data obtained by this test method are relevant and
appropriate for use in engineering design.
The values stated in SI units are to be regarded as standard. No
other units of measurement are included in this standard.
This standard does not purport to address all of the safety
concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety and
health practices and determine the applicability of regulatory
limitations prior to use.
NOTE 1—This standard and ISO 6603.2 address the same subject
matter, but differ in technical content. The technical content and
results shall not be compared between the two test methods.
*A Summary of Changes section appears at the end of this
standard