Cart
0
Product
Products
(empty)
No products
To be determined
Shipping
$0.00
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart.
There is 1 item in your cart.
Total products
Total shipping
To be determined
Total
Sale!
View larger
View larger
ASTM A275/A275M
New product
ASTM A275/A275M 2015 Edition, May 1, 2015 Standard Practice for Magnetic Particle Examination of Steel Forgings
More info
Description / Abstract:
This practice2 covers a procedure for magnetic
particle examination of steel forgings. The procedure will produce
consistent results upon which acceptance standards can be based.
This practice does not contain acceptance standards or recommended
quality levels.
Only direct current or rectified alternating (full or half wave) current shall be used as the electric power source for any of the magnetizing methods. Alternating current is not permitted because its capability to detect subsurface discontinuities is very limited and therefore unsuitable.
Portable battery powered electromagnetic yokes are outside the scope of this practice.
NOTE 1-Guide E709 may be utilized for magnetic particle examination in the field for machinery components originally manufactured from steel forgings.
The minimum requirements for magnetic particle examination shall conform to practice standards of Practice E1444/E1444M. If the requirements of this practice are in conflict with the requirements of Practice E1444/E1444M, the requirements of this practice shall prevail.
This practice and the applicable material specifications are expressed in both inch-pound units and SI units. However, unless the order specifies the applicable "M" specification designation [SI units], the material shall be furnished to inch-pound units.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2 For ASME Boiler and Pressure Vessel Code applications see related Method SA-275/SA-275M in Section II of that Code.
*A Summary of Changes section appears at the end of this standard
Only direct current or rectified alternating (full or half wave) current shall be used as the electric power source for any of the magnetizing methods. Alternating current is not permitted because its capability to detect subsurface discontinuities is very limited and therefore unsuitable.
Portable battery powered electromagnetic yokes are outside the scope of this practice.
NOTE 1-Guide E709 may be utilized for magnetic particle examination in the field for machinery components originally manufactured from steel forgings.
The minimum requirements for magnetic particle examination shall conform to practice standards of Practice E1444/E1444M. If the requirements of this practice are in conflict with the requirements of Practice E1444/E1444M, the requirements of this practice shall prevail.
This practice and the applicable material specifications are expressed in both inch-pound units and SI units. However, unless the order specifies the applicable "M" specification designation [SI units], the material shall be furnished to inch-pound units.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2 For ASME Boiler and Pressure Vessel Code applications see related Method SA-275/SA-275M in Section II of that Code.
*A Summary of Changes section appears at the end of this standard