Cart
0
Product
Products
(empty)
No products
To be determined
Shipping
$0.00
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart.
There is 1 item in your cart.
Total products
Total shipping
To be determined
Total
Sale!
View larger
View larger
ASTM A269
New product
ASTM A269 2013 Edition, October 1, 2013 Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing for General Service
More info
Description / Abstract:
This specification covers grades of nominal-wallthickness,
stainless steel tubing for general corrosion-resisting and low- or
high-temperature service, as designated in Table 1.
The tubing sizes and thicknesses usually furnished to this specification are 1⁄4 in. (6.4 mm) in inside diameter and larger and 0.020 in. (0.51 mm) in nominal wall-thickness and heavier.
Mechanical property requirements do not apply to tubing smaller than 1⁄8 in. (3.2 mm) in inside diameter or 0.015 in. (0.38 mm) in thickness.
NOTE 1—Additional testing requirements may apply for use in ASME B31.3 applications.
Optional supplementary requirements are provided and, when one or more of these are desired, each shall be so stated in the order.
The values stated in inch-pound units are to be regarded as standard.
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
*A Summary of Changes section appears at the end of this standard
The tubing sizes and thicknesses usually furnished to this specification are 1⁄4 in. (6.4 mm) in inside diameter and larger and 0.020 in. (0.51 mm) in nominal wall-thickness and heavier.
Mechanical property requirements do not apply to tubing smaller than 1⁄8 in. (3.2 mm) in inside diameter or 0.015 in. (0.38 mm) in thickness.
NOTE 1—Additional testing requirements may apply for use in ASME B31.3 applications.
Optional supplementary requirements are provided and, when one or more of these are desired, each shall be so stated in the order.
The values stated in inch-pound units are to be regarded as standard.
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
*A Summary of Changes section appears at the end of this standard